AEG X92384MI0 Instrukcja Użytkownika Pobierz pdf (Strona 16)

EN - INSTALLATION

FIXING THE FRAME

•Loosenthetwoscrewsfasteningthelowerchim-

ney and remove this from the lower frame.

•Loosenthetwoscrewsfasteningtheupperchim-

ney and remove this from the upper frame.

If you wish to adjust the height of the frame, proceed

as follows:

•Unfasten themetric screwsjoiningthe twocol-

umns, located at the sides of the frame.

•Adjusttheframetotheheightrequired,thenre-

place all the screws removed as above.

•Insert the upperchimney stack fromabove, and

leave it running free on the frame.

•Lift up the frame, fit  the frame slots onto the

screws up to the slot end positions.

•Tightenthetwoscrewsandfastentheothertwo

screws provi-ded with the hood.

Before tightening the screws completely it is possible

to adjust the frame by turning it. Make sure that the

screws do not come out of their seats in the slotted

holes.

•Theframemountingsmustbesecuretowithstand

the weight of the hood and any stresses caused by

the occasional side thrust applied to the device.

On completion, check that the base is stable, even

if the frame is subjected to bending.

•Inallcaseswheretheceilingisnotstrongenough

at the suspension point, the installer must provide

strengthening using suitable plates and backing

pieces anchored to the structurally sound parts.





1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

Brak uwag

AEG X92384MI0 Instrukcja Użytkownika Strona 16