AEG 8509 D Instrukcja Użytkownika Pobierz pdf (Strona 16)

Wall unit mounting - Fig. 6

 Mark the wall with a centre line, this will aid mounting procedure ,

position the template so that the mid line printed on the template

matches with the centre line previously drawn (1), drill two holes Ø

8mm (2).

 Fit two wall plugs with hooks (3).

 Hang the hood and adjust its position (4).

 Remove the grease filters (5) and from the inside of the hood mark 4

points for fixing (6). Remove the hood and drill 4 holes Ø 8mm.

 Fit two wall plugs (7).

 Fit the chimney support (8) with wall plugs and screws close to the

ceiling, check that the support is perfectly centered.

 Hang the hood again and fix securely with 4 screws (9) .

 Connect a tube to the exit hole of the hood (10) long enough to reach

the outside (suction version) or the deflector connection ring (filtering

version).

 Make electrical connection (11).

 Fix the chimney up (12a) to the chimney support (12b).

 slide the lower section of the chimney down into the housing on top

of the hood (13).

1 2 ... 11 12 13 14 15 16 17 18

Brak uwag

AEG 8509 D Instrukcja Użytkownika Strona 16