AEG F88722IM0P Instrukcja Użytkownika Pobierz pdf (Strona 21)

14. INSTALLATION

14.1 Installation

If floor is not level, adjust

levelling legs to suit

The hose should not be

extended by more than

2 metres or water pump-

out

problems may occur

Removeentire plastic

membranefrom sink trap

spigot & fit drain hose to spigot

with clamp

Thereshould be a minimum

2mm gap between the top of

the dishwasher and

underside of bench top

Gap on both sides should be

equal, & no greater than

5 mm per side.

Secure dishwasher with

brackets or screws provided

Min. 400 mm straight

section

600mm max

300mm min

400mm

min

DISHWASHER

SINK

POWER OUTLET

Install the appliance under a kitchen

counter.

Put the appliance adjacent to a water tap

and a water drain.

For the venting of the appliance only

water hoses and mains cable openings

are necessary.

14.2 Adjusting the level of the

appliance

A correct adjustment of the level of the

appliance allows the door to close and

seal correctly.

If the door does not close correctly,

loosen or tighten the adjustable feet to

level the appliance.

14.3 Water connection

Water inlet hose

Connect the inlet hose to a water tap

with an external BSP thread spout of

3/4''.

For best washing performance it is

recommended to connect the appliance

to a cold water supply.

Energy savings can be made by

connecting the appliance to a Solar

water system and using economy

options, however the water temperature

must not exceed 60° C.

Inlet water supply

• Water pressure: 800 kPa max - 50 kPa

min.

• Water flow rate 10 L / minute min.

• If water pressure is in excess of 800

kPa, a pressure reducing valve should

be used. Check for leaks.

• If water temperature is in excess of

60° C, a tempering valve should be

used. Check for leaks.

ENGLISH

21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Komentarze do niniejszej Instrukcji

Brak uwag